Viper 1.3 Serial Key Full Version

Viper was designed to be a PC VSTi FM / additive synthesizer that can create range of leads , pads and basses.

Here are some key features of "Viper":

· Uses 4 oscillators to create sounds , each oscillator can be modulated by any other oscillator (including itself for self -modulation) creating a possibility of up to 65536 different modulation setup. Each modulator can use frequency or ring modulation to create an enormous variety of different possibilities . Combined with this each oscillator has symmetry & pulse width modulation control and oscillator syncing

· A seperate version of Viper is included when you purchase Viper where the oscillator are 2x oversampled to create much better oscillator sounds at higher frequencies

· Over 100 additive waveforms in plus the normal analogue waveform, allow for a wide palette of source sounds

· Two multi-mode filters , with 12/24 db low/high/band pass/notch filters plus ring modulation , comb filter and formant filter for vocal sounds

· 6 AHDSFR envelopes with variable curvature and 6 LFO's . These can control all the major parameters, using a simple to use modulation matrix . Plus full midi control of all the controls using midi learning

· Step Sequencer with up to 16 steps which also can be used in the modulation matrix to create trance-gate sounds & simple sequences

· Chorus , stereo delay & stereo widener

· 200 presets + full manual (thanks to Jomal , EJR & Daniel Lewis for their presets)

Requirements:

· VST Host such as Cubase, 500MHz PC with 64 Mbytes of memory. Vocal has been test using Cubase VST / SX , Traction, Fruityloop, Orion, Chainer , & should work with other VST hosts, and as a DirectX plugin using the FXpansion Vst-Dx V3/4 or Directxer adapaters

Limitations:

· the demo version only works for 10 minutes.